Precedente
Successivo
ATR902-12ABC
ATR902 is a hand-held programmer specifically designed for automating small hobby or professional kilns often used in ceramics firing , glass fusing or goldsmithing.
ATR902 allows the programming of 15 cycles/curves with time-dependent temperature control. Each cycle can contain up to 18 steps/segments, all freely configurable by the user as up/down/down.
Cycle programming and visualisation are simple and intuitive, even for non-expert operators.
Typical furnace control software functions are provided: Delayed Start, End-of-Step Wait (in case of process delay at the programmed setpoint) and Cycle Recovery Mode (after any power failure).
The multi-pin connector, which is also compatible with the previous ATR900/901 series, allows the user to make an immediate connection/installation. The pin-out specifications are detailed in the documentation and allow manufacturers to correctly set up the corresponding connector on the oven.
The input is programmable for the most common thermocouples and there are two selectable outputs as control or alarm/auxiliary.
All options are configurable from the keypad (probe type, alarm mode, cycle programming).
ATR902-12ABC PLUG-IN PROGRAMMER/TEMP. CONTR.15 CYCLES 4+4 Digit 1 AI-2 RL-24/230V
€385.52
Tax included
FEATURES
| Dimensions | 120x65x65mm |
|---|---|
| Power supply | 24..230V AC/DC ±15% 50/60 Hz - galvanic isolation 2,5KV |
| Consumption | 3 Watt/VA |
| Operating conditions | Temperature 0..45 °C, humidity 35..95 RH% (non-condensing), max 2000m a.s.l. |
| Material | Box: PC UL94V2 self-extinguishing, front panel: PC UL94V2 |
| Sealing | Front panel: IP54, Box and terminal blocks: IP20 |
| According to | CE |
| Analog inputs | 1x 16bit, K,S,R,J,T,E,N (automatic compensation of the cold junction 0..50°C, precision @25°C ±0,2% F.S. ±1 digit F.S.) |
| Sampling time | Programmable up to 2,1ms (frequency up to 470Hz) |
| Relais outputs | 2 x 1A - 250V AC resistive loads |
| Control algorithms | ON - OFF with hysteresis, P., P.I., P.I.D., P.D. time proportional |
| Tuning | Manual or automatic |
| Alarm mode | Absolute / Threshold, band, High / Low deviation, timed auxiliary programmable on single steps |
| Software parameter configuration | Memory Card, software LABSOFTVIEW, EASY-UP codes - Programming via APP (NFC) "MyPixsys" for Android and iOS devices |